Ignition Component Tester
For Testing
Coil Over Plug Ignitions
Conventional Coils
Coil Packs DFI Coils
Dis Modules
Ignition Module / Igniters
Optical Sensors
Hall Sensors
Inductive Sensors
Speed Sensors
Crank and Cam Sensors
Injectors
Fuel Flow and Pressure Test
O2 Sensor Test
Special Features:
- New! Measure fuel flow and pressure min/max capture (Optional accessory)
- New ! Test O2 sensors measure cross count min max capture / lean, rich status / sensor output voltage
(Optional accessory)
- New! Voltmeter min/min capture.
- Current ramps ignition components, does not require current clamp or calibration
- Record amperage waveforms and replay in 100u second increments
- Able to display, record and replay peak amperage draw
- Diagnose ignition components without removal from vehicle
- Measure and display fuel injector pulse width (milliseconds)
and duty cycle (%) with min/max capture
- Measure, capture and record voltage drops and rises - user configurable
- Produces a continuous spark, with adjustable frequency settings
Measure injector and coil trigger signals
- Pulse width in milliseconds
- Duty cycle in percentage %
- Minimum and Maximum readings
Current Ramping of ignition components
- Record and playback complete waveform
- Diagnose shorted, open circuit and poor performing ignition components
Detect and record missing pulses
- Detect intermittent missing pulses as small as 100µ seconds long
- Configurable to detect a variety of faults.
- Counts and stores in memory the number of times the faults has occurred
Capture and Record Voltage
- Detect intermittent voltage drops that may only occur for a short period of time
- Counts and stores in memory the number of times the fault has occurred
Full Colour pin out manual 200 pages
Ability to Read , Display , Record and Replay amperage Waveform
Less than the price of a decent multimeter but with a heap more diagnostic functuality!
Part# IMT45P
Full set of leads for testing hundreds of different components. Not all supplied test leads shown.
Click to download Brochure (pdf format)
The EDEA ignition system tester is designed to quickly test common EFI components and help diagnose no start and intermittent faulting vehicles. It can test a variety of components including injectors, modules, coil over plug systems, DFI Modules, coil packs, conventional coils, crank sensors, inductive pickups, ignition leads, rotor buttons and distributer caps. Used in the correct manner this tool has proven itself to thousands of technicians to be able to quickly diagnose problems that would otherwise have taken an extended period of time.
Click to download instructional 44 page Extra testing procedures manual in pdf format, 1.3 MB file size.
Updated 01/03/2016 Version 9.6